10mm Twinwall Corotherm

Published product information

Detail & guidance

• Available in clear and bronze

• Light weight glazing sheet

• UV resistant for durability

• Durable and hardwearing

• Minimum condensation risk

• Largely self-cleaning

ideal for

• Greenhouses

• Sunscreens

• Swimming Pool Covers

• Vertical Panels

• Plant Houses

• DIY Glazing Projects

Refer to the Corotherm installation guide and installation video for complete installation instructions.

Energy Efficiency - Relative U-Values*

*A lower U-value indicates increased energy

General

• Make sure the clearly marked UV protected side of the sheet is facing outwards

• Allow a minimum of 10° roof slope for water drainage

• Use only low modulus neutral cure sealant and cross-linked butyl flashing tape

• The flutes of the sheets must run from top to bottom of the slope, never from side to side

• Sheets cannot be joined top to bottom

Cutting Corotherm can be easily cut and will not crack or shatter. When cutting parallel to the flutes a sharp knife can be used but when cutting across the flutes a fine toothed saw is required. For cutting curves use a fine toothed jig saw.

Thermal Expansion When installing Corotherm sheet it is important to allow a sufficient expansion gap at the top end of the sheet. When drilling fixing holes an expansion allowance of 3mm around all fixings is required. Do not fix or clamp sheets too tighly - leave room for thermal movement.

Cleaning Corotherm can be easily and quickly washed with luke warm soapy water and a soft cloth or sponge. Do not use brushes or sharp objects and avoid any abrasives or cleaners of high alkaline nature.